NeuroTrac® Continence with Serial Number

Used with either a vaginal or anal probe it treats both urinary and faecal incontinence, making it suitable for men and women. It can also be used with skin electrodes placed near the pelvic floor muscles. Please note the probe/electrodes are not included; see important information below.

The NeuroTrac Continence is easy to use, compact, light and reliable, and with its nine built-in programmes, it provides a choice of treatment options. Three customisable constant-mode programmes enable you or your clinician to tailor the training to your specific needs. The unit can be locked allowing your clinician to review your progress at your next appointment. It provides a level delivery throughout the programme, the muscles are stimulated at a constant hertz or strength.

The NeuroTrac Continence has two channels that can be controlled independently, meaning you can use both a vaginal or anal probe to combat both urinary and faecal incontinence. 

The Neurotrac Continence is very compact and easy to use, it has 9 pre-recorded programs: 

• 2 programs for the treatment of stress incontinence
• 2 programs to treat bladder instability
• 2 programs to treat  mixed incontinence
• 1 program to improve  vaginal sensitivity
• 1  pelvic floor strengthening program
• 1 analgesic program intended to alleviate  pelvic pain
• The device also offers 3 free program ranges.

Features:

• Digital Dual Channel Stimulator (NMES) is used to treat urinary incontinence by sending a mild electric current to nerves in the lower back, tibialis nerve or in most cases, to the pelvic muscles using a probe.
• Suitable for urinary or rectal incontinence.
• 9 Built-in programmes for ease of use.
• 3 Customisable constant mode programmes.
• Ability to lock the unit and records total time in use and average current.
• Clear bright backlight LCD allows the display to be read more easily in low light or dark conditions.
• Keypad with bigger buttons for ease of use.
• Compact, light and reliable.

Specifications:

• Dual-channel: individually isolated circuits.
• Amplitude: 0-90 mA into 500 Ohm load; actual mA will tend to be less than indicated due to electrode impedance: at 1000 Ohms load (Electrodes in poor condition) the maximum will be limited to 86 mA, at 1500 Ohms load the maximum will be limited to 65 mA.
• Type: Constant current, maximum output voltage 180 Volts +10 / -30 Volts
• Waveform: Asymmetrical, rectangular bi-phasic with zero DC current.
• Selectable pulse width: 50 μS – 450 μS [2% accuracy].
• Pulse Rate selection: in the continuous mode 2 – 100 Hz [2% accuracy].
• Time duration of the treatment selectable: 1 minute to 90 minutes.
• Low Battery Indicator: If the battery goes below 6.9 volts +/- 0.2 volts the battery symbol will flash on/off once every second.
• Open Electrode Detect: If an open circuit is detected at the output of channel A or B the output current will be reset at zero.
• Ramp up time 0.3 – 9.9 seconds.
• If the battery voltage is below 6.6 (+/- 0.2) volts the unit will not turn on
• Physical Dimensions: 119.2 x 69 x 28.7 mm
• Weight: 0.1KG with battery

What is Included:

• 1 x Neurotrac Continence Unit
• 1 x Pack of 4 Electrodes
• 1 x 9V Battery
• 2 x Leads
• 1 x User Manual
• 1 x Carry Bag

Nappi Code: 188019-001

GMDN Code: 46573

Warranty

This model carries a warranty of 2 Years from the date of purchase. The warranty applies to the simulator only. The warranty does not apply to the leads or electrodes.